*Note: If you are unsure what version of Windows 95/98 you are using, right-click on My Computer and choose Properties. Under the System tab, you will see the version of Microsoft Windows. If it reads Windows 98, you are using Windows 98. If it reads Windows 95 and the version number is followed by the letter B, then you are using Windows 95B. If it reads Windows 95 and the version number below it is not followed by a letter, you are using Windows 95A.

Inside Dial-Up Networking, you should see an icon labeled, WonderWave.net. If so, right-click on the icon. From the menu that appears, choose Properties. If not, click on Make a New Connection to enter the Setup Wizard. Upon creating your WonderWave.net connection, you will need to return here to configure the connection.

Under the General tab, make sure that your access number (Phone number) is correct, then click on Configure at the bottom.

Under the General tab, make sure your Maximum speed is set properly with respect to your modem's speed. A 14.4 Kbps modem should be set to 19200, 28.8 Kbps should be 38400, and 33.6 Kbps and 56 Kbps modems should be 57600. Then click on OK.

Under the Server Types tab, make sure that the Type of Dial-up Server is set to PPP.

In Advanced options, make sure that Enable software compression is the ONLY box that is checked.

In Allowed network protocols, make sure that TCP/IP is the ONLY box that is checked.

Click on TCP/IP Settings.

In TCP/IP Settings, make sure that Server assigned IP address and Specify name server addresses are selected.

Make sure that the Primary DNS reads 208.49.144.10 and that the Secondary DNS reads 69.220.182.10.

Make sure that both Use IP header compression and Use default gateway on remote network are checked.

Click on OK and then on OK again.

Note: In addition to configuring Dial-up Networking, it is also important to check out the settings in the Network Control Panel .

© 2003 wonderwave.net